The RCM drive by wire electric throttle body has been designed and engineered specifically for Subaru applications, for vehicles using a reversed inlet manifold configuration.
Manufactured from machined billet aluminum housings, it is fully assembled and ready to bolt directly to your reversed manifold,...
This simple adptor bolts into place on your block, where you can remove an existing bung. It allows for a Defi type sensor to be installed to monitor either oil temperature or oil pressure, depending on your needs. This removes...
RCM's own Fuel Pressure gauge, for use with RCM fuel pressure regulator. Essential when fitting an aftermarket regulator, to ensure adequate fuel pressure is present.
If you require the RCM Fuel Pressure Regulator (not included), please see here
RCM 3 port boost controller kit, with plug and play adaptor.
Direct Plug and play fitment on MY99+ Subaru Impreza WRX/STI/Turbo/GT models.
Essential for any modified Subaru running larger turbochargers and/or higher than factory levels of boost pressure.
Utlising the same Pierburg...
RCM Individual coil pack conversion loom. This kit is a direct plug and play conversion wiring loom which allows V5/6 vehicles from 1999-2000 normally fitted with a single coil pack to run 4 x individual coil packs from the 2001+ models for improved ignition performance...
CLEANS: WD-40 gets under dirt, marks and grease making it easy to wipe away. It also dissolves adhesives, allowing easy removal of labels, tape, and stickers
PROTECTS: WD-40 protects metal surfaces with corrosion-resistant ingredients to shield against...
Genuine Subaru temperature sensor, this sensor is for the ECU and Fans, not the temperature gauge.
Genuine Subaru vehicle speed sensor. This sensor fits into the gearbox.
Genuine Subaru oxygen / lambda sensor, as fitted to V1/2 WRX imports with the EJ20G Engine Code.
Genuine Subaru knock sensor. This is fitted underneath the inlet manifold.
Genuine Subaru oil pressure switch. This is fitted to the majority of Subaru engines between 1989 and 2015.
Genuine Subaru oxygen / lambda sensor, as fitted to Legacy's with engine codes EJ20H/EJ25D
Genuine Subaru air flow meter, as fitted to V3 WRX.
Genuine Subaru oxygen/lambda sensor, as fitted to BH5 Legacy's with engine codes EJ206/EJ208
Genuine Subaru electronic speed sensor for manual 5 and 6 speed vehicles
Genuine Subaru oxygen/lambda sensor, as fitted to WRX from 08/2000+
Genuine Subaru variable camshaft timing sensor, as fitted to WRX/STI from 04/2001
Genuine Subaru airflow meter, as fitted to WRX STI from 04/2000
Genuine Subaru air/fuel ratio sensor, as fitted to STI from 09/2002+
Genuine Subaru neutral position switch, fitted to 6 speed Impreza's