Filters
Subaru
314 products
Showing 25 - 48 of 314 products


A Genuine Subaru Camshaft Oil Seal for non VVT Impreza's from V5 on, 08/1998+.


A Subaru rear Crankshaft Main Oil Seal.


A genuine Subaru Crankshaft front main oil seal, this presses into the front of the oil pump assembly.


We can offer the full range of trims and clips for the Subaru range of cars. This is a complete Subaru roof trim clip kit used to secure the roof mouldings or trims on 4 door and 2 door Subaru Impreza GC8 models. This clip kit helps hold th ...


This is a genuine Subaru Impreza Wiper Arm Nut Cover. Over time, these shrink and become a loose fit resulting in them falling out.


This is a sump washer for RCM Magnetic Sump Bung - RCM2761


LH Rocker Cover Gasket to suit V9+ Impreza's with the following engine code - EJ255 EJ257 EJ207 (JDM)


Genuine Subaru turbo oil drain pipe and clips


Subaru Impreza's are now becoming collectors cars, and restorations are becoming more and more popular. One part which is no longer available from the manufacturer is the scuttle panel seal which sits between the scuttle panel and the bonne ...

A Genuine Subaru fuel filter for cars from 1992 - 2007.


Standard Subaru Sump Pan, to fit all 2.0 Single Scroll Turbo engines.

This is a genuine Subaru Crankshaft Position Sensor. As with any Subaru electronic sensor, to ensure the correct level of performance, reliability and part longevity, our advice would be to always use the genuine Subaru part and to stay awa ...

A Genuine Subaru Clutch & Brake Pedal Rubber. 36015GA111


LH Rocker Cover Gasket to suit V5-V8 Impreza's with the following engine codes : EJ205/EJ207

A genuine Subaru Water Transfer Pipe O Ring. 2 will be required per car.


A Genuine Subaru Water Pump Bolt available individually or as a kit of x6 bolts that secure the water pump to the block assembly.

This Subaru JDM STi Titanium key is a great little accessory, perfect for personalising your Subaru. This comes as a blank that will need cutting to match your existing key profile for it to work. It is only compatible with vehicles that do ...


This is a complete Cylinder Block Rebuild Kit, which contains all of the gaskets and bolts required to rebuild your short engine. Suitable for all EJ series engines including EJ20, EJ22 and EJ25. Parts included in this complete kit are; • 1 ...


A Genuine Subaru Exhaust Valve Stem Oil Seal. These we sell individually, as a pack of x8 or as a pack of x16. With our high powered RCM engines we replace the x8 black inlet stem seals and fit x16 exhaust stem seals in an engine as the mat ...


This is a genuine Subaru Block Case Bottom Stud for Gearbox Bell Housing.


The Subaru stars grille badge in black was unique to the euro specification turbo models and is now available from Roger Clark Motorsport as a replacement part for the Classic Impreza MY1992-2000. Has your existing badge discoloured?.....w ...

A genuine Subaru clutch release bearing for all 5 and 6 speed pull type clutches. Also compatible with Exedy multiplate, paddle and organic clutches.


Genuine Subaru Fuel Pump Housing Gasket. This is the gasket located on top of the fuel tank, and seals between the tank and the cover which the fuel pump is attached to.


Genuine Subaru Clutch Cover Bolts. You will need x6 cover bolts per car.
Filters